Review: MGW billet accessories
www.mgwltd.com

The E-Brake Handle
We like the look of this cover. It is made in such a way that it appears intergrated in the handle itself so it looks good.

Handle Installed

It's also available in a mirror chrome finish.

Installing the handle

It's a very straight forward installation, simply slip the handle over the factory e-brake. The handle is a VERY tight fit. The instructions mentioned using some armorall, we used some dish soap. Apply a layer to the handle and inside the new billet cover. Then slip it on.

The underside has 2 set screws. The handle fits pretty tight without them, but for extra mounting, you can tighen these after you install. Make sure they are backed out before sliding the handle on. The plus side to the tight fit is that this cover will never accidently slide off even during heavy E-brake use.

Nice thing about these parts is that they were designed for a perfect fit in a Mustang as compared to generic knobs or E-brake handle covers. Everything lines up and because of that look great. Gives your stang that limited edition look.

Coming up soon is the MGW new front billet Grille and rear plate frame...

That's it, til next time, see ya on the street !...

MUSTANGWORLD.COM, the Mustangworld crest logo above and MOLLERNET are registered trademarks of MoLLER DIGITAL / DiscMEDIA INC. Copyright © 1986 - 1998 MoLLER DIGITAL. Some web elements on this site are copyrighted and are being used with permission from their respective owners. MUSTANGWORLD web elements may not be "re-posted" on any website anywhere in the free world without permission from MoLLER DIGITAL INC. All original graphics are digitally watermarked to aid us in copyright enforcement. .